INCH-POUND
MIL-C-46793C(ME)
24 April 1992
SUPERSEDING
MIL-C-46793B (ME)
28 October 1983
MILITARY SPECIFICATION
CUPOLA BODY ASSEMBLY FOR ARMORED VEHICLE
BRIDGE LAUNCHER, M6OA1 AND M48A5 TANK CHASSIS
This specification is approved for use within the USA Belvoir Research,
Development, and Engineering Center, Department of the Army, and is available
for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1
Scope. This specification covers the cupola body assembly required
for the armored vehicle bridge launcher, M6OA1 and M48A5 tank chassis.
2.
APPLICABLE DOCUMENTS
2.1
Government documents.
2.1.1 Specifications and standards. The following specifications and
standards form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those listed in the
issue of the Department of Defense Index of Specifications and Standards
(DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
Beneficial comments (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document should be
addressed to: USA Belvoir Research, Development, and Engineering Center,
ATTN: STRBE-TSE, Fort Belvoir, VA 22060-5606 by using the
Standardization Document Improvement Proposal (DD Form 1426) appearing
at the end of this document or by letter.
AMSC N/A
FSC 5420
DISTRIBUTION STATEMENT A.
Approved for public release; distribution is
unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business